Morningstar SunSaver 6 Solar Charge Controller 12V 6A

In stock
Morningstar SunSaver 6 Solar Charge Controller 12V 6A
Morningstar SunSaver 6 Solar Charge Controller 12V 6A

This Morningstar Sunsaver 6 solar charge controller is part of the third generation of SunSaver charge controllers.

These charge controllers are ideal for small professional and consumer systems. The circuit boards on these units are fully encapsulated in epoxy resin, which means they are resistant to dust ingress and humidity.

This epoxy encapsulation also means the SunSaver 6 is approved for Class 1 Division 2 hazardous locations, such as those present in the oil and gas industry. (See data sheet for exact specifications).

The unit has marine rated terminals for cable connection and includes a terminal cover.

There is a setting for sealed or vented batteries and this setting can be adjusted on the unit itself. 

Features include:

  • 3 LED's indicate to battery charge state and load disconnect condition.
  • Full electronic protection & dead battery recovery feature.
  • 4 stage battery charging
  • Self-diagnostics to detect critical faults
  • Telecom mode for sensitive loads
  • Optional automatic low battery voltage disconnect (L). (Not on this unit).

Since its first market introduction in 1996, over 1 million SunSaver controllers have been installed in over 73 countries for various solar power systems including: oil/gas, telecom and instrumentation, marine and boating, and remote homes.

System Voltage 12V
Solar Current 6A
Load Current 6A
Low Voltage Disconnect No
Self Consumption <8mA
Humidity 100% Non-condensing
Charging Method 4 Stage PWM
Dimensions 15.2 x 5.5 x 3.4 cm
Weight 0.23Kg
Wire Size 5.0mm sq. / #10 AWG
Temperature -40 to +60 Degrees C
Protections Over Load, Over Voltage, Reverse Polarity, High Temp, Lighting, Reverse Current at Night, Surge.
Display LED Indications for battery and system status.
Warranty 5 Years

Write Your Own Review
You're reviewing:Morningstar SunSaver 6 Solar Charge Controller 12V 6A
Your Rating