Marlec Controller Interface Lead

Rutland Wind Turbine Controller Interface Lead

The Marlec (Rutland) battery charge controllers are pre-programmed with regulation settings to match Lead-Acid batteries.

The Marlec charge controller universal reprogram software enables you to change the voltage regulation levels and other parameters for the HRDi, Rutland 1200 Controllers (Marine & Terrain) and the Rutland 1803 MPC-2 Controller to suit alternative battery types. This often the case when using lithium batteries.

Configuration of the controller is carried out in a few simple steps:

1. Plug the USB end of the cable into your PC and install the drivers.
2. Insert the supplied USB stick into your PC and extract the application.
3. Connect a DC power supply to the battery terminals of the controller to power the controller up, ensuring this is the correct system voltage for the controller/turbine you have i.e. 12V DC or 24V DC etc.
4. Connect the cable to the data port of the controller and use the Marlec program to change the settings on your controller.

Full detailed instructions can be found on the PDF by clicking on the Manuals & Datasheets tab above.